Tile cutting problem

[Italy]

You have mounted a new wheel, the sigma?

 

[Italy]

I also remember, that all still available tiles, sent in uk.
because there, there are tilers with thick skull.
As andy
Ahah sorry,sorry

 

[Time's Ran Out]

call the manufacturer of the tiles and explain how to make the cut. I've already done.

What did they say ?

Get a proper tiler in!

 

[Italy]

Get a proper tiler in!
Yes, yes. I did not want to offend andy ,ahah

 

[Andy Allen]

Cutting every one on the wet cutter now...

 

[andy-p]

I had a similar problem with fired earth porcs a few years back , full tiled bathroom . tried everything .. had to use my bridge cutter !!

 

[Time's Ran Out]

Tried cutting them on the back?

@Houston - if you think it's silly try it and see!

 

[RayL12]

Hi all,


As some of you know, I'm in my 7th week, of 16, on a Wall & Floor tiling course; lvl 2 Diploma.

Though this might not answer the question, I soon learned that the gap in between the 'planks' of the aluminium 'Step-Up', was perfect to slip a 150mm^2 tile in to create perfect slim 8mm, and less, wide pieces.

So, there's a tool that someone can invent; a Ste-up/Trestle with an adjustable plank. Or, does it exist already?

...Ray.

 

[GAZ5518]

Recently I was in on a Rubi "Breakfast Morning" where the rep had the same problem cutting a particular Matt finished rivened tile..That tile had an extra middle sandwich material...
I have often just scored that type of tile and "whacked it on the straight of a corner of something.. Giving it an even pressured break.... Invariably works for me...

 

[LM]

Hi all,


As some of you know, I'm in my 7th week, of 16, on a Wall & Floor tiling course; lvl 2 Diploma.

Though this might not answer the question, I soon learned that the gap in between the 'planks' of the aluminium 'Step-Up', was perfect to slip a 150mm^2 tile in to create perfect slim 8mm, and less, wide pieces.

So, there's a tool that someone can invent; a Ste-up/Trestle with an adjustable plank. Or, does it exist already?

...Ray.

You've lost me Ray?

 

[RayL12]

My introduction post, Lee

 

[andy-p]

I'm lost

 

[LM]

I think I still must have missed something Ray but your introduction was a good one ​

 

[Andy Allen]

Hi all,


As some of you know, I'm in my 7th week, of 16, on a Wall & Floor tiling course; lvl 2 Diploma.

Though this might not answer the question, I soon learned that the gap in between the 'planks' of the aluminium 'Step-Up', was perfect to slip a 150mm^2 tile in to create perfect slim 8mm, and less, wide pieces.

So, there's a tool that someone can invent; a Ste-up/Trestle with an adjustable plank. Or, does it exist already?

...Ray.

Are you in the correct thread ?.. ..your answer makes no sense at all..

 

[Profix]

try scribing the first 75mm at each end without coming off the tile then a single scribe to break, or scribe another line 10-15mm onto the waste and take this off carefully with your snips after snapping it in the machine, if it veers off it should stop at the first proper cut line