Tile marking guide...Tile Boss

[Gazzer]

[video=youtube;-dOblqbaBLk]http://www.youtube.com/watch?feature=player_embedded&v=-dOblqbaBLk#![/video]

 

[Gazzer]

[video=youtube;tPrjzScSJ0M]http://www.youtube.com/watch?NR=1&feature=endscreen&v=tPrjzScSJ0M[/video]

 

[Dan]

I've seen the first video before. Not sure if I'd use that though. I can use the actual tile I'm going to cut and get the marks perfectly.

So if I was going to do the cut in the first video, I'd place the full tile up against each edge and mark the side of the tile at the end where it overlaps the fixed full tile. Do that on each edge in both directions, and then transfer the marks to the points where they meet. You would end up with exactly the same markings as he had on the tile when he took it to the cutter.

And it doesn't matter if walls are not square etc as you can follow the contour using that method.

 

[Furtek]

May be useful for me. but the quality of plastic which is made does not convince me to pay the 50 pounds for this.

 

[Tony73]

same as mitre wizz- waste of money.