Discuss UFH - Costs in the UK Tiling Forum area at TilersForums.com.

G

Gazzer

The tiles will become warm depending on the insulation below the UFH.
This was sent to me by a cement tile backer board manufacturer

Unfortunately thermal values are a minefield because there are differing standards, as here, and different ways of measuring them. However, in real life comparisons with cable underfloor heating the following approximate results were observed:

1. Onto bare concrete slab – took about 3 hours to reach max temp of 24°C.
2. Onto No More Ply 6mm – took about 40 minutes to reach 24°C and 3 hours to reach max temp of 27°C.
3. Onto Beavaboard 6mm – took about 30 minutes to reach 24°C; temperature 29°C at 3 hours and still increasing.

If you are going to use No More Ply under wire underfloor heating, you must remember to prime the surface with Mega® SBR as this helps to reflect the heat back up.

In summary No More Ply reduces warm-up time, increases efficiency and allows a greater maximum temperature. Beavaboard is cement-coated foam board of the same type as recommended by underfloor heating companies, and has the same effect but to a greater extent.
 

Reply to UFH - Costs in the UK Tiling Forum area at TilersForums.com

Subscribe to Tilers Forums

There are similar tiling threads here

    • Like
Renovated the bathroom on my 1970 bungalow last year. Took up the old pink floor tiles with sds...
2
Replies
25
Views
2K
Been advised to move this post to the uk forum, didn’t realise it was in the USA forum Would...
Replies
2
Views
697
hello new here but wished i had found and asked before screed and ufh down but here goes. We...
Replies
12
Views
2K
Hi! I'm looking for some advice, I have laid some SLC (Mapei 1210) in our conservatory in...
Replies
5
Views
1K
P
Hiya I know this was 10 years ago hoping you still use the same email address and get this...
Replies
1
Views
729

Trending UK Tiling Threads

UK Tiling Forum Popular

Please visit our sponsor websites, they keep the forum free to use!

Advertisement

Thread Information

Title
UFH - Costs
Prefix
N/A
Forum
UK Tiling Forum
Start date
Last reply date
Replies
9

Thread Tags

Which tile adhesive brand did you use most this year?

  • Palace

  • Kerakoll

  • Ardex

  • Mapei

  • Ultra Tile

  • BAL

  • Wedi

  • Benfer

  • Tilemaster

  • Weber

  • Other (any other brand not listed)

  • Nicobond

  • Norcros


Results are only viewable after voting.

You're browsing the UK Tiling Forum category on TilersForums.com, the tile advice website no matter which country you reside. Our UK based online tiling forum has 48,000 members and started out in 2006.

Top