What Drives Your Drill Bits

[ANDY F]

Just purchased the Porsadrill kit and on first use I'm chuffed to bits with it. Guides work well, nice clean hole, no mess, top job!

Just wondering what everyone uses to power their bits though. Put mine in an 14volt cordless. Although this is slow and not mega powerful, its just a nice speed that doesn't get out of control.

However, was only drilling bumpy white ceramics. For anything thicker or harder, I'm guessing I'm going to need more power. What does everyone else drill with?

Cheers,

 

[p4ulo]

I've got a pair of Makita 18v old school drill-drivers, and 2 batteries. I could really do with another battery, but don't see the point in changing to Li-ion technology because I'd have to replace both drills too....
Batteries and stuff is cheap, and a body drill-driver was cheap as when I needed to get a second.

 

[The D]

I've got a pair of Makita 18v old school drill-drivers, and 2 batteries. I could really do with another battery, but don't see the point in changing to Li-ion technology because I'd have to replace both drills too....
Batteries and stuff is cheap, and a body drill-driver was cheap as when I needed to get a second.

you need this LIONDAPTER Makita Battery Single Adapter 18V Tool Repair Recycle

 

[J Sid]

An angle grinder

 

[Wishiwasatoptiler]

Hitachi 18v 2 of those fancy new batteries and 30mins charger. Great when you rock up to board a bathroom and find both batteries are dead. Like I did tonight. Quick boost owner on the charger while cutting boards and good to go.

 

[dave l and l]

dewalt 18 v . old driver was really good, recently bought 18 v dewalt from trade point. both the batteries are poor 1.5 a h dont last at all, going to buy a couple of decent batteries for it ..

 

[ANDY F]

Get the impression that the cordless is generally the way to go. Will wait till mine burns out then invest in a 18v jobbie

 

[Old Mod]

Like Julian, for the main, variable speed grinder for me, nice slow start and loads of grunt!
And an SDS for my less common size bits.
Oh and don't lend your drill bit's to the plumber either, they nause them up very quickly! Grrrrrr

 

[Toffolo]

Same as 3_fall, flex variable speed grinder/polisher with m14 thread. Great for polishing and cutting holes.

 

[p4ulo]

I had an email from TRADEPOINT about these last night.....bonkers price!!!!

Makita Cordless 18V Li-Ion Combi Drill 2 Batteries HP457DWEX2 | TradePoint

 

[Bill]

I had an email from TRADEPOINT about these last night.....bonkers price!!!!

Makita Cordless 18V Li-Ion Combi Drill 2 Batteries HP457DWEX2 | TradePoint

Price is about right for the amperage on them....look at the price for 3/4/5 amp battery.