working with sheet-mounted glass mosaics-suggestions needed for solving a problem

[Rob Z]

The Leonitt nippers worked really well (thank you Gisela). The only aggravation was working with the paper-face mounted stuff. For the mesh mounted stuff nibbling away with these biters was a breeze.

I used the Festool Rotex 90 sander to clean up, grind, and polish edges, as needed. Festool sells pads which can be used to polish cut edges.

I'm waiting for the decorative glass panel to get installed, and then I'll get some photos to share.

Thanks for the help. I hope everyone is doing well over in the UK. We've been busy/hectic over here.

Richard, that's a fine looking installation! Very nice.

 

[MTiler]

Update: the Leonitt brand biters recommended by Gisela arrived this afternoon. I went into the shop tonight and experimented with some cuts, and it is just as G. said it would be...great tip MG-I'm glad I have this tool now. Thanks again Gisela

They are good, I use them all the time with mosaics