would like some advice please guys

[mike111]

I have put some new plasterboard up in the shower area and have a leg kit for the stone shower tray which is fitted and i levelled the tray and sorted the waste but not fixed to floor yet.
I have the bal tanking kit/bal single part flex/bal microflex grout/solid bed trowel.
This is where i need some advice with the correct method, there are some ceramic screw heads in the plasterboard,do these need filling if so what with,should i
(1) tank down past the tray and tape the corner
(2) silocone around the tray before fixing in place
(3) tile the area
(4) fit cubicle
(5) silocone corner and along the shower tray again and around cubicle

or should i fit a sealux trim and tank the walls/tile/fit cubicle/silocone corner and cubicle


please give me some advice guys mike

 

[wetdec]

Hi

To get a 100% tank you would need to seal the floor as well or use a membrane down over tray seals which is the easiest and most secure.

Tiler

 

[mike111]

thanks wetdecs . is there anyone with more advice on the correct method of sealing a raised shower tray using the bal tanking kit

 

[Ger]

This type of installation (BAL WP1) is detailed in animation on www.waterproofingshowers.com

The PDF 'Get Connected' explains the benefit of a Sealux seal

 

[mike111]

Thanks wetdecs for your help on the phone, top bloke, top advice,thanks again.

 

[malcolml]

best advice is to ring bal tec helpline or go on the web site:ninja: