Hi all....
Now I know that plywood is not the best substrate to tile onto, especially walls. Problem is that most builders still use the stuff so you just have to make do. Could I get a few comments from those who have been in the trade for some time about preferred methods of substrate...
Ok, I'm sorry if this has already been mentioned but i couldnt find this exact problem!
I have just about finished stripping some old tiles off a bathroom wall. Over some quite large areas, the wall under the tiles is just bare render that is not in good condition and needs levelling/covering...
Hi,
I have laid a new wood subfloor (caberfloor water resistant) and have some underfloor heating mat to go down and granite tiles to finish, but have conflicting instructions as the heating supplier said lay insulation boards then mat then tiles. but the tile box says lay on top of wbp. what...
Hi All.
Been a while since I have posted on here and i trust you are all keeping well.
I have been procrastinating over getting my wood burner installed as I need to sort the hearth out 1st. The wife has now stopped dropping hints and is actually making threats if i dont get it sorted before...
Gazebo
Thread
aus
black
hearth
preparation
quarry
tile
tiles
tiling
usa
Hi guys I have a quite common question but maybe I could get a precise answer to few questions. Im looking at tiling hall and kitchen in 1950? semi-detached. Hall and half a kitchen got floorboards and the other half concrete.
So I would like to do a good job with sub floor preps and here arise...
Hi Everyone,
Newby to this excellent looking Forum and I hope I can be a help in the future. I have just lifted a load of worn out old cork tiles from our porch and my intention is to lay some ceramic floor tiles. The surface is sound concrete but has some remains of the cork tile adhesive...
Have taken old tiles off solid wall in kitchen. The skim coat of plaster has come away with them leaving sand/cement base coat which is in good condition. The skim coat was only about 1-2 mm thick. Do I need to get the walls re-skimmed before re-tiling to get a decent finish on the new tiles, or...
I am about to start tiling my bathroom floor and would like to get the pro tilers opinion of the floor preparation and adhesive choice before I get going and stick the tiles down.
The floor is a 22mm T&G chipboard floor glued and screwed to the joists/noggins around all edges, this has been...
I'm preparing the floor of our bathroom prior to putting down some Amtico tiles. I'm putting down a couple of sheets of 6mm WBP ply and my question is : is there any smoothing / feathering compound I can buy in small tubs to do the joints between the boards? It just seems overkill to buy a...
Hi, I am preparing my hall for Victorian tiling, its floor boarded so I am plating it with ply first, do I need to seal the ply with anything before I lay the tiles down?
Thanks in advance.
Shaun77
Thread
aus
edwardian
edwardian floor
floor
geometric
preparation
tiling
usa
victorian
victorian floor
victorian floor tiling
Just doing a bathroom reburb. The floor is to be tiled in 600x600x10mm porcelain tiles. Bathroom size approx 2.5mx2.5m.
As I had to lift a lot of the floorboards for the new pipework, I decided to replace the lot with 18mm WBP ply. The plan then was to use Ditra and then tile. I'm just a little...
ir50
Thread
aus
floor
format
large
large format
large format porcelain
porcelain
porcelain tile
porcelain tiles
preparation
tile
tiles
usa
Hi All, several questions; how long should I leave newly plastered walls before tiling the bathroom? Can I get away with priming walls with Bal SBR or Prime APD prior to tiling and are these suitable for both plaster and plasterboard? Or, should I use Mapai Primer as I'm thinking of using...
Hi there - DIY job - Not tiled at all before so bear with me.....!
Ripped out old bathroom - dimensions 4m * 1.4m
It's a first floor extension built on to the side of the house so one long wall is plastered brickwork (seems very sound), one end wall is a rebuilt 4*2 stud partition to next...
I have about 360 sq. ft. to tile in a basement, and I was wondering if I should etch it or what to do to prep. I have tiled concrete before with no special prep, but this is a basement finishing job for a customer and I don't want to take any chances. Also, there are control joints cut, so do I...
Hi all,
Please excuse me if this is not the correct section to post this in...
I'm currently renovating my bathroom in a small back to back terrace 1915 circ. I've already made a few mistakes which thankfully reading this forum I've been able to catch in time (tile weights on plasterboard)...
Hi All,
I'm Looking to tile my first floor in the utility room And need some preparation advice for the concrete floor.
The Floor is partly painted rough concrete but seems level judging from my spirit level,
I'm unsure iF the surface is suitable for me to just go ahead and start laying my...
PaulJ220
Thread
advice
aus
ceramic
ceramic tile
concrete
floor
needed
preparation
tiling
usa
Hi chaps.
Just want to run a job past you that i've just looked at.
Been to see a 33m2 garage floor. It has been down for 6 years, and is power floated. The client has painted the floor, but being power floated it has flaked. Now he wants it tiled. The floor is flat, dry, has no oil or...
I am looking for advice on whether I need to put down either an overboard (tilebaker, wedi, hardie, ply, etc); a decoupling matt (Ditra, etc) or neither......
The details are:
The room is a small upstairs toilet (i.e. not a wetroom nor a bathroom)
Travertine honed & filled...
I'm a DIYer and have tiled sucessfully with tiles up to 20x30 and tubbed adhesives. Bought these 30x60 double fired ceramics without realising the extra problems you face. Read lots of good stuff on this forum but please check my thinking and warn me if I've got things wrong.
Three walls are...
Hello,
I have fitted John Guest Speedfit "between the joist wet underfloor heating" and want to lay 40x40 travertine tiles on the floor. Should I use 22mm water resistant chipboard as suggested by John Guest for a generic tile (not specifically travertine and I suspect this is driven from a...
DMHunter
Thread
floor
heating
preparation
ufh
underfloor
underfloor heating
usa
wet