I'm tiling an en-suite shower (it has one of those bog-standard heavy cast-concrete (?) and enamel bases if that makes a difference).
I am not an experienced tiler, so I'm doing my learning.
Looking on the YouTubes, nobody seems to be using that concave shower tray trim anymore, (that would go...
I have a 995mm x 995mm built in shower in the corner of my small bathroom. The the mixer was not centred properly on wall, so it sits a little off centre. The genebra and shower rail are on the adjoining wall. Should I centre the mixer on the one wall within the 600 x 300 tile and tile outwards...
Good morning.
I’ve been trying to work out how to stop my shower tray from moving!
I’m fitting a complete en-suite and someone before has run the shower waste above the floor boards etc so I have to use a riser kit or build it up. (Floor boards run under the partition into another room).
I...
Having had my wooden skirting replaced below our shower with some UPVC, I’m left with a 15mm gap between our floor tiles and the new UPVC skirting.
The bloke that did the job filled it with wall tile grout and it’s cracked and looks pretty bad
Any ideas on how best to fill this gap? Going to...
I am currently tiling a shower area.
Field tiles are installed with space for a vertical 300mm vertical feature/ border and a 100mm horizontal border.
Both horizontal and vertical borders will be fitted with glass mosiac tiles of different designs but both of a depth of 7mm.
I have used the...
Hi. I am a diy. My first job so dont go all crazy on me. I do have an issue, my inside corners have large joins. Its cause wall goes in. How do i best hide it?
I will be getting some modifications done to a shower for my mother, who is elderly and disabled. I'll be getting someone to remove the shower screen and raise the shower floor level to be flush with outside. The primary focus is having a non slip surface in the shower. I've been recommended R10...
Have just noticed movement in the steel shower tray at the corner edge. I have tiled the adjoining floor tiles so now am unable to remove the tray from its position as it is butt up against the wall - see photo
options - tile onto the tray whilst in its lower position so it can’t rise when...
Good morning all. Hoping an expert will be able to advise me as I'm dreading making a very expensive mistake
I am planning to lay the mosaic tiles pictured onto a wet room shower tray former, I have bought larger porcelain tiles for the rest of the bathroom, was worried about cutting them in...
Hi folks, I have been doing a lot of research as to which is the best tanking product to use on our shower walls prior to tiling.
The walls are currently made up of prowarm 12mm cement board and there is a 900x900 quad stone resin tray on the floor which I want to tape and seal to the wall...
Hello,
Bought a new construction home in January 2019 in Orlando. After living in the house for about 6 months, I realized that my master bathroom shower floor was not draining properly. Started seeing discoloration, and mildew around all the areas that were not draining properly. The shower is...
Looking for recommendation for a sealant for wall and floor tiles in a shower room.
Wickes Emperador Marble Mix Mosaic Tile are on the floor and plain white glazed tiles on the wall.
Hi All, I'm getting my head around converting our wetroom (vinyl) back into a bathroom (with a tiled floor).
The current sub floor is:
Floorboards then
6 mm ply then
2-3mm of some grey material (slc?)
a thin layer of brown adhesive
some lovely non slip vinyl.
I'm currently thinking to strip...
Hello,
We have chosen a painted decorated 20X20cm tiles for the bathroom with a walk-in shower and wanted to make the tiles pattern as seamless as possible. Are the tiles small enough to create fall to to drain without cutting them diagonally? I can settle for slopes that are 95% perfect and...
amiti
Thread
drain
fixing
former
showershowertray
slope
tile
tiles
wetroom
Hi All,
I've not been doing this for too long, so still a little unsure in a lot of things! Was on Ana architect lead job last week into this coming week and would appreciate your opinions on the setting out of this shower former.
One option is mine, one is the architects, so which is best...
Hi everybody, Iv been a member for 3-4 years now but more of a watcher than a contributor. Now I need a bit of advise so apologies, I’m about to start a large bathroom with a walk in shower, I’ll be doing this with sheeting the walls with backer board and fully tanking the full room as I always...
Hi all,
We had a new wetroom put in a few months ago. The tiler was recommended to us but anothr friend also used him recently and his work was very substandard and I can no longer get hold of him.
The shower floor grout went dark as soon as it got wet (presumably normal) but it quickly...
I’ve had to move shower tray about 50mm away from the wall so that the waste is not over a joist, what can I do to bridge the gap?
I was thinking to fill it with Wedi board and the tile over it? Any suggestions?
Thanks
Hi,
I need to repair the tiles shown in the photo. This is a shower stall where the grout failed and water got behind the tiles. The wall board was wet but not soggy. This is on a first floor; there is no sign of water leaking in the basement. The surrounding tiles are solid. I will be...
Hi,
new here and after some advice on fitting a raised stone resin shower tray.
The shower tray comes with a raised upstand kit which is a fixed height.
Do you set the shower base at the height of the upstand plus the 10mm floor tiles plus the tile adhesive?
That seems the most obvious to me...