Dry cutting porcelain tiles

[Old Mod]

These are better, but not the cheapest.

Cutting bench for large format tiles

• Old Mod
• Nov 8, 2015
• 2
• cutting bench heavy duty large format

Assembling heavy duty cutting bench for large format tiles.

Cutting bench for large format tiles

• Old Mod
• Nov 8, 2015
• cutting bench heavy duty large format

Assembling heavy duty cutting bench for large format tiles.

 

[Kyle Knowles]

These are better, but not the cheapest.

Cutting bench for large format tiles

• Old Mod
• Nov 8, 2015
• 2
• cutting bench heavy duty large format

Assembling heavy duty cutting bench for large format tiles.

Cutting bench for large format tiles

• Old Mod
• Nov 8, 2015
• cutting bench heavy duty large format

Assembling heavy duty cutting bench for large format tiles.

Ohhh very sexy I'm jelous

 

[Kyle Knowles]

What are they called ?

 

[Old Mod]

Jawbone sawhorse

Cutting bench for large format. - http://www.tilersforums.com/media/albums/cutting-bench-for-large-format.1478/

 

[Diggy]

8mm for me too = 01959

Its the one rec'd for porcelain , ( 3 stars in the catalogue )

 

[Fraser Tiling]

Thanks Ray TT, at last a reply that makes sense.
Will sort myself a thicker bedded surface for my cutter and try again cutting at waist height.
To be fair, cutting on the floor is awkward at times, and usually cut smaller tiles on my Tx700 without problems.
I like my Tx1200, mostly used for ceramic wall tiles, deals with most porcelanosa bathroom tiles upto 1100mm and cuts well, being advised to ditch it and spend another 5-600 notes on the equivalent Sigma cutter is ridiculous.
Once again, cheers for the advise, will give it a go with a new 8mm wheel.

 

[macten]

Make sure you get the gold wheel

 

[Fraser Tiling]

Make sure you get the gold wheel

Fairly sure they dont make a gold 8mm wheel, but they do a 10mm gold.

 

[macten]

Yep yep you're right

 

[Rizzle from the Portizzle]

Fairly sure they dont make a gold 8mm wheel, but they do a 10mm gold.

depending what surface you are cutting if its smooth i would start with a 6 mm wheel it gives a far sharper
fracture line and deeper a little oil will let it run a lot smoother