Grout sealing by LTP sealer's

[user123]

With these sealers... is it true that you have to reapply them every two years at least? And is that what you tell the customer then? It's just I notice in my own bathroom, at some parts the grout is starting to get wet rather than before it just perled off, just seems odd and a bit frustrating, to have to rely on the customer then, when all is done and finished... I am thinking about my mosaics of course... and outdoor work...

 

[DHTiling]

All depends on what you clean the tiles etc with G.. High Ph cleaners will lessen the life..

If in doubt reseal..🙂

 

[user123]

I have more questions about my bathroom that will take photos and another thread... but as mentioned in the mold thread, I dry my shower walls with a microfibre cloth and only use a bathroom shower spray around twice a week when in a rush, or sometimes after drying it...if I reseal, don't I seal possible spores inside it? That has held me back so far...

 

[DHTiling]

If you have no mould spores then you will be fine... also you have the homelux membrane and that should stop anything hitting the substrate.

 

[user123]

Ah ok, I didn't think the spores were always visible, like too small in the beginning? Well remembered about the membrane, I'm impressed! 🙂 Do have an issue on a small part of the Silicon to the bath, but will take photos in better light... really irritating..

 

[DHTiling]

Strip it out and re-do... hot water cannot damage Silicon..🙂

 

[user123]

Strip it out and re-do... hot water cannot damage Silicon..🙂

Done that three times... :nonod: have two places where these black holes appear.. always the same places... :nonod: I have this sneaking suspicion... as I remember you mentioning once adhesive poking through, that may that is what it might be? Remember Mike put the bath in, THEN I did the tanking... the bottom edge may let have a bit seep out? It bugs me every morning...

 

[DHTiling]

Done that three times... :nonod: have two places where these black holes appear.. always the same places... :nonod: I have this sneaking suspicion... as I remember you mentioning once adhesive poking through, that may that is what it might be? Remember Mike put the bath in, THEN I did the tanking... the bottom edge may let have a bit seep out? It bugs me every morning...

Good....

 

[user123]

:lol: thanks... :lol:... it was my turn to be on the receiving end... 🙂

Do you think it could be the addy?

 

[DHTiling]

Need a pic..?