Discuss Recommendations- The best knee pads??? in the Canada Tile Advice area at TilersForums.com.

Fraser Tiling

TF
Esteemed
117
608
High Wycombe
Bought these a few weeks ago, posted on another page.
My opinion.
Hello again fellas, bit of feed back for you.
Been using my old pads until they wore out since buying the Toughbuilds.
Been doing 150x75mm wall tiles in a small bathroom in an old cottage, no room, part half tiled with a silly amount of separate faces and bundles of trim.
Used the hard shell clip ons.
Took ages to get them to clip onto the base pad, and unsure if they all pushed on properly.
As soon as I knelt down, my knee rolled very easily, and after twenty minutes, the edge of the pad at the top was pin pointing alot of weight on my knee cap as they won't sitting high enough. I decided to give them time to wear in and mould to my knees. A couple of hours later they we're still uncomfortable.
I took them off to check I had them on the correct left or right leg.
Both were, and noticed they felt more like a foam pad than a gel pad.
After showering the next morning I noticed my the back of my legs we're very sensite from the straps rubbing, once again, I decided to give them a chance to wear in, and give them another day. Thinking over tightening may have caused the rubbing and bad positioning, I loosened the straps a bit more than yesterday.
Nothing much improved today, and one of the clip ons fell off whilst visiting Screwfix.
Got home tonight and checked my legs whilst changing out of work clothes, this is what I found.
20180201_175142.jpg
20180314_210017.jpg 20180314_205821.jpg 20180314_210001.jpg
 
L

LM

Bought these a few weeks ago, posted on another page.
My opinion.
Hello again fellas, bit of feed back for you.
Been using my old pads until they wore out since buying the Toughbuilds.
Been doing 150x75mm wall tiles in a small bathroom in an old cottage, no room, part half tiled with a silly amount of separate faces and bundles of trim.
Used the hard shell clip ons.
Took ages to get them to clip onto the base pad, and unsure if they all pushed on properly.
As soon as I knelt down, my knee rolled very easily, and after twenty minutes, the edge of the pad at the top was pin pointing alot of weight on my knee cap as they won't sitting high enough. I decided to give them time to wear in and mould to my knees. A couple of hours later they we're still uncomfortable.
I took them off to check I had them on the correct left or right leg.
Both were, and noticed they felt more like a foam pad than a gel pad.
After showering the next morning I noticed my the back of my legs we're very sensite from the straps rubbing, once again, I decided to give them a chance to wear in, and give them another day. Thinking over tightening may have caused the rubbing and bad positioning, I loosened the straps a bit more than yesterday.
Nothing much improved today, and one of the clip ons fell off whilst visiting Screwfix.
Got home tonight and checked my legs whilst changing out of work clothes, this is what I found. View attachment 97485 View attachment 97486 View attachment 97487 View attachment 97488
That’s nasty
 
L

LM

Bought these a few weeks ago, posted on another page.
My opinion.
Hello again fellas, bit of feed back for you.
Been using my old pads until they wore out since buying the Toughbuilds.
Been doing 150x75mm wall tiles in a small bathroom in an old cottage, no room, part half tiled with a silly amount of separate faces and bundles of trim.
Used the hard shell clip ons.
Took ages to get them to clip onto the base pad, and unsure if they all pushed on properly.
As soon as I knelt down, my knee rolled very easily, and after twenty minutes, the edge of the pad at the top was pin pointing alot of weight on my knee cap as they won't sitting high enough. I decided to give them time to wear in and mould to my knees. A couple of hours later they we're still uncomfortable.
I took them off to check I had them on the correct left or right leg.
Both were, and noticed they felt more like a foam pad than a gel pad.
After showering the next morning I noticed my the back of my legs we're very sensite from the straps rubbing, once again, I decided to give them a chance to wear in, and give them another day. Thinking over tightening may have caused the rubbing and bad positioning, I loosened the straps a bit more than yesterday.
Nothing much improved today, and one of the clip ons fell off whilst visiting Screwfix.
Got home tonight and checked my legs whilst changing out of work clothes, this is what I found. View attachment 97485 View attachment 97486 View attachment 97487 View attachment 97488
Have you tried Fento knee pads?
 
1
88
I use the alpro pads but got annoyed with them falling off and movin around,so went and got me some fento pro. These were comfy and light but not as well cushioned as the alpro , so took out the straps from the fentos (which you can buy separate) stuck em in the alpro, now perfect. Comfy and stay in place all day. Win Win!!
 

Fraser Tiling

TF
Esteemed
117
608
High Wycombe
I use the alpro pads but got annoyed with them falling off and movin around,so went and got me some fento pro. These were comfy and light but not as well cushioned as the alpro , so took out the straps from the fentos (which you can buy separate) stuck em in the alpro, now perfect. Comfy and stay in place all day. Win Win!!
Love your style, straps are far too loose on Alpros, plus once they become warn they become too coarse to use for grouting on sensitive tiles, so really need two pairs.
If only I was female and able to use "yarn and thread" to tighten the Alpro straps.
 

Reply to Recommendations- The best knee pads??? in the Canada Tile Advice area at TilersForums.com

Subscribe to Tilers Forums

There are similar tiling threads here

Hi there question re knee pads and rubi wheelie sit down thing( hopefully pic uploads ) I've...
Replies
4
Views
2K
gamer1
G
    • Like
    • Useful
Hi, Im looking for a recommendation for a liquid tanking. I have to use a liquid tanking...
Replies
1
Views
748
A question about mitering and matching epoxy colour I'll be working with some pinkish matt...
Replies
6
Views
2K
I've recently bought Johnson 'Orkney Stone' ceramic floor tiles from B&Q. Paid to have them...
Replies
6
Views
1K
Hi all , it’s been years since last posted for advice and your methods . My question is this ...
Replies
5
Views
970

Advertisement

Thread Information

Title
Recommendations- The best knee pads???
Prefix
N/A
Forum
Canada Tile Advice
Start date
Last reply date
Replies
35

Which tile adhesive brand did you use most this year?

  • Palace

    Votes: 9 5.8%
  • Kerakoll

    Votes: 15 9.6%
  • Ardex

    Votes: 11 7.1%
  • Mapei

    Votes: 46 29.5%
  • Ultra Tile

    Votes: 19 12.2%
  • BAL

    Votes: 37 23.7%
  • Wedi

    Votes: 4 2.6%
  • Benfer

    Votes: 2 1.3%
  • Tilemaster

    Votes: 21 13.5%
  • Weber

    Votes: 18 11.5%
  • Other (any other brand not listed)

    Votes: 17 10.9%
  • Nicobond

    Votes: 7 4.5%
  • Norcros

    Votes: 3 1.9%
  • Kelmore

    Votes: 4 2.6%
Top