Self Leveling Tips?

[hmtiling]

Crikey!.....right see why you want this floor perfectly flat before fixing!.....look forward to your post with how you got on with level pins......attach some pics bud

crikey!......yeah see why your looking at these

Should be fun

 

[aussie tiling]

Yeah, I can see the problem there. A few on here bed electric ufh in a thick rapid set with a grout float before slc. That or a glue gun. My job is wet ufh, so won't have that issue.

We did it in sections devi mat was used first which is good coz it stays down bar a few little bits, on the other s**te we ended up going round and duct taping down before pour but the mesh wants to pop up. If l put it down l would spray glued it but the sparky wasnt having any of it. Wet is the way to go if you have the room.

 

[Italy]

Let us know how you get on with them.....

not use rake marc ?
I use spade ......

 

[Stef]

Make sure there's no pipes under the floor before drilling....

Only using 25mm screws so they should be nowhere near the bottom of the floor boards.

 

[White Room]

Only using 25mm screws so they should be nowhere near the bottom of the floor boards.

I had a job where they had actually grooved out the bottom of the floor boards to allow for a water pipe to fit

 

[Stef]

Oh dear, saw pipes close to the underside of a few floors.

 

[Flintstone]

Ordered a 250mm vitrex roller, with splash guard, and 21mm spikes