Sticking new sponge for wash boy

[ECT]

Any suggestions for best glue to stick new sponges on.:stupid:

 

[grumpygrouter]

No more nails?

 

[DHTiling]

I use the spray contact adhesive.........

summit like this one.....works in mins...make sure the sponge board is dry...spray board and sponge leave for a couple mins then stick together....

 

[Gazzer]

As usual, what Dave says. I use it all the time and a can lasts ages.

 

[enduro]

I use the spray contact adhesive.........

summit like this one.....works in mins...make sure the sponge board is dry...sparay board and songe leave for a couple mins then stick together....

That's the one i use as well

 

[UKTT Darren]

Thats the one i use as well, for the best results, spray the plastic float then spray the sponge as well, leave for about 1 minuite and put the two together, job done, be carefull when you run the sponge through the rollers that you dont rip off the sponge from the float

 

[CJ]

As above regarding the spray glue.

Also..........when filling ya washboy, DON'T make the water toooo hot, as it melts the glue and the sponge falls off into ya lap :embaressed_smile: ok ok......we've all done it.

Have'nt we :whatchutalkingabout

 

[sWe]

As above regarding the spray glue.

Also..........when filling ya washboy, DON'T make the water toooo hot, as it melts the glue and the sponge falls off into ya lap :embaressed_smile: ok ok......we've all done it.

Have'nt we :whatchutalkingabout

Not me, cuz I use cold water

 

[DHTiling]

I use cold as well.....

why so hot CJ..?

 

[grumpygrouter]

Cold for me too. Don't normally have hot water available, anyway wouldn't it make the grout go off quicker?

 

[CJ]

I don't mean scorching hot.

But if there is warm water available, I'll use it for a final wash. Only because it's gonna dry off a bit quicker so the floor can be dry wiped. Just sometimes as I have asbestos hands..........the water is a bit tooo warm and the sponge has dropped off..........twice into my lap