What SLC to use over UFL

[Flintstone]

One I did on Friday, I needed to bring it up 10mm so I stuck 10mm squares of board in a few places and brought it up to that. The squares often look proud as they can get a raised bit of leveller sat on top of them

 

[Dumbo]

One I did on Friday, I needed to bring it up 10mm so I stuck 10mm squares of board in a few places and brought it up to that. The squares often look proud as they can get a raised bit of leveller sat on top of them

View attachment 95161

Looks like somebody got a work bench in the bathroom

 

[hmtiling]

One I did on Friday, I needed to bring it up 10mm so I stuck 10mm squares of board in a few places and brought it up to that. The squares often look proud as they can get a raised bit of leveller sat on top of them

View attachment 95161

What slc is that Andy?

 

[Flintstone]

Ah that’s part of a couple of bits to be clad in delta board and mosaic.

 

[Flintstone]

Tilemaster rapid level 30

 

[Dumbo]

One I did on Friday, I needed to bring it up 10mm so I stuck 10mm squares of board in a few places and brought it up to that. The squares often look proud as they can get a raised bit of leveller sat on top of them

View attachment 95161

I prefer to use screws to set heights as they can be set at different heights if substrate is uneven

 

[Flintstone]

On a wooden floor yes. Not so good on a solid floor!

 

[Flintstone]

If a floor is already flat and level and I’m fitting ufh I will just pour and not worry about setting height markers.

 

[Dumbo]

On a wooden floor yes. Not so good on a solid floor!

I find doesn't take long to drill and plug.

If a floor is already flat and level and I’m fitting ufh I will just pour and not worry about setting height markers.

That because you are better than me

 

[Rookery]

I do it by eye and hope for the best. Usually works out though, I've been doing it like that for years.