Which electric ufh system

[Flintstone]

I don't want to upset you, Wayne, but you have fitted that mat upside down, and you have made a fundamental error by taping over the cold tail connector like that, that must be left exposed and encased in the SLC .

 

[Wayne Brown]

Perposely did it like that bud well spotted hawk eye to protect the cable bud alot been going on in there floor levels were 40mm difference one to the other not worried about to heat the room as has a big towel rail and a rad it's more to dry the floor up after showering sensors blub is exposed is on top of insulation but thanks for the comments mate . Kop

 

[Flintstone]

Some would beleive you, but I don't ! And taping over that cold tail is the main cause of failure

 

[Spare Tool]

Andy's right Wayne, just for future installs the worse thing you can do is tape over the join to cold tails, and also the crimped end of the wires, think its something like 90% cause of ufh failures, tape the ufh wire down and the cold tail yes but leave a gap in the tape so the joins can be fully encased in slc, or ay the very least tile adhesive..

 

[Wayne Brown]

😉Point taken chaps every day's a school day have a nice weekend both of you .

 

[Time's Ran Out]

I always encase in fast set flexible adhesive (applied with rubber squeegee ) prior to self levelling compound.