sealant

Hi everyone, new to the forum and looking for some advise. Just finishing off installing my new bathroom which has been tiled top to bottom with gloss white bumpy tiles and black grout. Bath, sink and furniture is all white. What colour Silicon would look best around the bath/shower area and...

Hi guys, I recently had an indian sandstone patio installed, it looked great until I tried to seal it. After sealing I have been left with faint white spots on the slabs. I used a flouropolymer sealant which I put down on saturday. I believe this has been caused by the slabs not being fully...

Hi Can you please let me know if a product like Schlüter DILEX-EKE or equivalent internal profile trim is generally visually cleaner than using Silicon? I assume 3 way internal corners could look messy if not cut correctly but was wondering if I should go for some sort or trim like this for...

I purchased this kit lately as to stop me using finger and have used it a couple of times, first time I used a fine mist spray bottle with soapy water, second time I used kit dry and just used builders wipes to clean tool often. Must say I think Silicon took a very good hold onto both sides of...

Hi there I'm a DIYer restoring a shower in my house. The tiles are limestone. Grouting and tiles have been throughly cleaned - and grouting sealant applied. I'm now ready to apply Lithofin Stain Stop. Should it be applied before or after Silicon sealant? If before, how long must I leave it to...

Overview of Silicones Sealant Chemistries - http://www.adhesives.org/adhesives-sealants/adhesives-sealants-overview/sealant-technologies/sealant-chemistries Ref. Univar Specialty Consumables - https://www.univarsc.com/ Silicon sealant is actually quite a broad term that is used a lot...

I had an email showing sales of Unibond Sealants, Adhesives (75817 42139 (+dept_id:180) (+subdept_id:3295) - Search Results - Toolstation - https://goo.gl/btq8fP or +unibond +cat74offers - Search Results - Toolstation -...

What make is the most proven currently available mold / mildew resistant white grout and also white silicon sealant ? - is there something which will last forever ?

I have a fully tiled wet room, the floor is concrete and the transparent sealant along the corners / floor edges gets mould behind it very quickly. I have had to remove it twice so far and replace it within a few years. I have removed the sealant and re grouted the edges. I can't find out why...

Hi there, I am a local mastic man to Sussex and Surrey. If any bathroom fitters are in need, please visit my facebook page @jcsealants to find my contact nunber JC Sealant Services - https://www.facebook.com/jcsealants/ Kind Regards, Jack the mastic man

Hi there, I am a mastic/ sealant applicator based in Surrey and Sussex areas. I undertake any new sealant required after bathroom installations as well as a cut out and reseal service. Kind Regards, Jack

The new range of colours called “Set the mood” is divided into five collections: Serene, Traditional, Natural, Romance and Glamour, making it easier to choose the right grout according to the requirements of each tiling project and personal preference. Visit http://bit.ly/2qm4C9o for further...

Hi. I am looking to use a coloured BAL sealant (Micromax) to finish off my wet room. Within the spec sheet it states ' (a) Do not use shower for at least 2 weeks after completion of grouting – BS 5385:Part 4' And in another section it mentions a minimum of 7 days to use the shower. Walls...

Hiya guys New wetroom has a small leak. Its taken 3 months to show but I think I've traced it to a small section of sealant around the floor/wall edge that has dragged when tooled and another small section down the edge of a tile. At least I hope it is. Anyhow. Do I have to remove ALL of the...

Mapei Ceramic Product Training Day at Mapei Training Centre in the Midlands, UK.

Wet room 1 by kelvin posted Dec 7, 2016 at 3:51 PMHi all, Just completing a wet room and now need to make the decision for sealant along the bottom of the tile to floor edge. Would you use the Jasmin to the floor or the cement grey I'm undecided but would appreciate some input please. Kind...

Hi people Quick question; I have just laid a Porcelain tile (mosaic) to a floor for a wetroom. And will be grouting it today. But before I did I thought I would check to see if I should use a sealant first as they are a light coloured "shuttered concrete" effect and a was worried about shower...

Domosil - High-performance, general-purpose Silicon sealant for sealing joints 3 to 40 mm wide, on surfaces of non-porous materials such as glass, aluminium, porcelain (e.g. tiles), ceramic etc. It cannot be over painted. Data Sheet Click Link Domosil-s - High-performance, mildew-resistant...

One-component, coloured, elastic joint sealant. Used for pointing tile joints on walls or floors, especially where high elasticity is required (expansion joints etc.). Suitable for indoor and outdoor applications. Available in seven colours: White (01) Grey (03) Light Grey (05) Dark Grey (10)...

Hello all. Got some chunky 14mmx600x1200 porc that looks like it's got a resin top 3/4mm which is meant to look like stone. There are some small holes in the top bit which i'm going to gout and the client has been given kf satin stop to seal. Will do a little test tomorrow but has anyone used...