tray

  1. A

    How best to remove old shower tray

    Hello all Having been very pleased with our bathroom refurb two years ago after finding this site very helpful, we're now onto the en-suite. Its shower has an old stone shower tray which is well cemented in place. What's the best way to remove it? Suggestions much appreciated!
  2. J

    Shower tray on Hardibacker board?

    Hi all, newbie here, we are in the process of refitting our small bathroom and would really appreciate any advice you could give us: 1: We are still in the process of knocking off the old tiles in preparation for plastering, do I fit the low profile shower tray before or after plastering? 2...
  3. K

    Tray fromer, UFH and SLC

    I was wondering what you guys would do in this situation. I have a 30mm trayfromer which will be fitted at joist level most likleyan Orbry as the drain offset is about right to get around the joists.The problem i was looking it was how to install the UFh loose wire and still come level with...
  4. O

    Cuts on orbry tray

    Hi. I have just bought a orbry 30mm wetroom tray. 1200x900. It has a linear drain. I am looking for advice on the cuts as it has a 2degree fall but the sellers reckon I need to make a mitre from each corner to each corner of the drain? I have not decided on 300x300 or 400x400 so any advice...
  5. V

    Tray former

    Hello guys, Just been having a good look through the forum. I'm currently looking at options for installing a DIY wetroom floor in a recently built ground floor extension. The space for the shower area , is 1000*950. The floor is concrete and there is a 110mm drain going down vertically, off...
  6. J

    shower tray question

    hello all, just wanted to ask if anyone knows of a shower tray that finishes flush with the surrounding tiles. the client wants a shower tray as opposed to a marmox/wedi shower former that's then tiled as they don't like envelope cuts and are not keen on mosaics either. i don't normally get...
  7. P

    Shower tray - fixing...

    Hi, I fitted a shower tray about a month ago. To do this I pulled up the current floor boards where I wanted the tray and replaced with 18mm ply. I have then fixed with Keraquick with some latex mixed in. Its been down about a month and today after cleaning some tiles with some warm water I...
  8. D

    Low level shower tray

    Hi, new to forum & would like a little advise. A customer wants 2 bathroom installations & wants walk in showers but with tiled trays set at about 3" from the floor level, can anyone advise on a good make of shower tray that would be most suitable. I want one at 1700mm x 760mm & one at 1550mm x...
  9. P

    Can I get hold of a replacement tray for a Dewalt d2400?

    Someones wages will be getting docked this week due to him cutting the tray in half! I didn't think it was possible, but it is. Is it possible to get a replacement tray? Thanks in Advance Lynn
  10. E

    marmox tray and drain

    Hi peeps Just ordering bits for a job ive got coming up has any body had experience with a company called Tilefix. I'm on a very tight budet for the job and trying to save as much as possible every penny counts and all that. There 800x800 tray and drain are £21.61 cheaper than phg who i normally...
  11. A

    Ufh on to Pre formed wet tray

    Hi there just wondering how everyone else would tackle tiling inch square mosaics over warmup ufh on a preformed lux elements wet tray ?
  12. M

    Plasterboard oN or behind resin shower tray?

    Hi all, I am getting conflicting messages from my builder and plumber regarding fixing a new resin shower tray in a new bathroom. The builder wants to recess the tray so the plasterboard butts on top of the tray, but the plumber wants to fit the tray flush against the board and then have the...
  13. I

    Sealing Shower Tray with flexible grout.

    Hi, I'm a plumber with (after reading some of this forum, very) limited tiling experience. After fitting a shower tray at a friends house, it has been set on 18mm ply on floorboards and set into the wall by approx 20mm as corner not square, silicon sealant around back edges. Friend has then...
  14. S

    Travertine shower tray

    Hi we have installed numerous travertine shower trays with success , however ... Recently after a year or so i have had people coming back to us saying they have cracked ??? ... They have always been solid bed fixed with white flexi and we have used ditra matting too as an extra precaution ...
  15. R

    Adhesive bed too thick, so stick warm up boards to AKW level best tray

    Dear all, First time and hoping for help! I have a AKW tuff form / level best tray installed (by builder) to create a level access shower and, because of various issues the tray is now at least 20mm below the level of the finished floor porcelain tiles around it. I plan to lay 10mm x 50mm x...
  16. E

    tiling against a qudarant shower tray

    Hi, Upstairs ensuite with T&G floorboards. Entire floor overboarded with WBP ply. Area under quadrant shower tray has two more layers of WBP, in the same shape as the tray but slightly smaller, so the tray overhangs by about 2cms. I have fully tiled the floor, cutting tiles in a curve so they...
  17. D

    Cut wall or cut tray

    Hi, I'm having one end of my bathroom made into a wetroom, I have a retired professional tiler to do the job, unfortunately wetrooms were not in vogue when he was working, so he's are following the instruction leaflet. Everything's gone well so far, the subfloor drain and the marine ply...
  18. Dan

    Shower Tray Formers

    Shower Tray Formers - PHG Wetrooms Checkout the shower tray formers from PHG Wetrooms.
  19. M

    Shower tray smaller than recess

    Hi, I've posted this on the plumbers forum but it seems that I should really have posted here first... I'm fitting a shower in an en suite and the gap for the shower tray is about 1060mm whereas the tray is 1000mm. Further info about the room: The entire room is already aqua boarded and the...
  20. M

    tiled wet room shower tray leaking

    Hi There, I recently tiled a wet room for someone, after only 2 weeks of use i was called back to investigate a leak. it appears that the pre formed tray is flexing and when you stand on it a 1mm to 2mm gap opens along the back wall. Are these trays supposed to flex like this? or is the tray not...

Advertisement

Top