A recent wet room project.

[Old Mod]

Utilising a shower former design I saw somewhere on line, a few months back I believe, I completed this wet room a few weeks ago.

It's a 1200 x600 x 10mm porcelain from Mandarin Stone.

The short walls I re-fabricated the 1200's down to 600's so that I could keep the bond with the floor.

All externals were mitred, of course, and the shower screen was sunk beneath the thing to give a completely frameless look.

One reason for the set out was that the drain and diverter were miss aligned, and a conventional set out would have highlighted this.

The window was actually offset to the joint line by approx 20mm also, but with a little jiggery pokery I was able to visually put it in the right place.

A lot of messing about? ..... yeah, maybe.

But the look on the clients face when completed, more than made up for the extra bit of hassle.

Plus they were a joy to work with.

 

[Blunt Tool]

Hope this isn't for jotm as I can see it 😛

 

[Old Mod]

Hope this isn't for jotm as I can see it 😛

No Ian, it's not. 😀
It's just for your enjoyment! Haha 😛

 

[Blunt Tool]

Very nice Marc, a lot of thought been put into that project aswell as skill!
Ps where's the bog roll holder?

 

[Blunt Tool]

Or do they use the 3 shells? (Demolition man)

 

[Old Mod]

Ps where's the bog roll holder?

I don't think they need one Ian, they're very religious! 😛

 

[J Sid]

love the wet deck, nice 🙂

good colour grout match , what did you use marc?

 

[One Day]

Not bad Marc, not bad at all...
You'll make a decent tiler yet...!

 

[Old Mod]

love the wet deck, nice 🙂

good colour grout match , what did you use marc?

Thanks Julian, actually took me two days of running around to find a match with Silicon.
You may remember me asking the question few weeks back. It's Bals micromax 2 gun metal.

 

[Old Mod]

Not bad Marc, not bad at all...
You'll make a decent tiler yet...!

Well that's why I didn't enter it in to jotm Mark, wasn't sure if I was up to it! 😛




Thank you!