Discuss How best to Tile a room? in the DIY Tiling Forum area at TilersForums.com.

T

Time's Ran Out

At the end of the day it is a personal opinion as to which way looks the best.
Sometimes we are instructed to set out against our advice and other times we make the decision. A lot can be dependant on the design of the tile and the need to follow a pattern around ( such as book match) and the colour of a travertine piece.
All I'am saying is putting a bit of furniture over the tiling is not one of the factors that would decide my setting out!
 
O

Old Mod

At the end of the day it is a personal opinion as to which way looks the best.
Sometimes we are instructed to set out against our advice and other times we make the decision. A lot can be dependant on the design of the tile and the need to follow a pattern around ( such as book match) and the colour of a travertine piece.
All I'am saying is putting a bit of furniture over the tiling is not one of the factors that would decide my setting out!
I think you're taking things to an extreme there John in the way you're deciding to translate previous posts.
If the guy is in, what he considers to be his home for life, and he wants to see 3 full tiles throw the main entrance to his kitchen, but it leave a smaller cut to one side, which will be hidden amongst fixtures and fittings, why the hell not?
How far have you got to stand back to see a room
4-5m wide and be able to take it in within your peripheral vision?
Saying a space has to be centred without exception is just short sighted and not what we're paid to do.
We're there to give the client what he wants and the best possible finish.
When have you walked off a job because you weren't allowed to centre a room? Haha
 
M

mp3wizard

Morning all, makes a change for me not to be centre of an argument. I understand that it is the done thing to centralise it usually, but there 800mm tiles I'd rather see a full a tile as possible for majority of room, rather than make 2 cuts, I know there will be some furniture on that side but it's not all about hiding it, I personally don't see it being terrible, needs to be cut somewhere, that would mean having a cut by bifolds and entrance, I'd rather just have a cut by bifolds. My bathroom is extremely small so again being able to see huge tiles going under bath with fewer visible cuts would be my preference, and same for kitchen, as cabinets will be sat over perimeter.
 
T

Time's Ran Out

I think you're taking things to an extreme there John in the way you're deciding to translate previous posts.
If the guy is in, what he considers to be his home for life, and he wants to see 3 full tiles throw the main entrance to his kitchen, but it leave a smaller cut to one side, which will be hidden amongst fixtures and fittings, why the hell not?
How far have you got to stand back to see a room
4-5m wide and be able to take it in within your peripheral vision?
Saying a space has to be centred without exception is just short sighted and not what we're paid to do.
We're there to give the client what he wants and the best possible finish.
When have you walked off a job because you weren't allowed to centre a room? Haha
Not sure if you even read my post with this reply!
 

John Benton

TF
Arms
2,203
1,138
Leeds
Who's
Morning all, makes a change for me not to be centre of an argument. I understand that it is the done thing to centralise it usually, but there 800mm tiles I'd rather see a full a tile as possible for majority of room, rather than make 2 cuts, I know there will be some furniture on that side but it's not all about hiding it, I personally don't see it being terrible, needs to be cut somewhere, that would mean having a cut by bifolds and entrance, I'd rather just have a cut by bifolds. My bathroom is extremely small so again being able to see huge tiles going under bath with fewer visible cuts would be my preference, and same for kitchen, as cabinets will be sat over perimeter.
You will have to make 2 cuts, if you come square off the bi-fold doors
 
T

Tile Shop

I'm not even going to pretend that my advise is up there with other time served Tilers in terms of setting out as I haven't had to do it often. But, if I had centred my kitchen floor tiling to the whole room, I would have had a 2 inch slither in front of my units on one side and almost a full tile on the other. Would have looked poo. So I centred it from the main focal point and the largest visible area.

Now the only visible "slither" is 4 inches wide in front of a stepped door way right opposite another door so you do see it when you enter the room from one end. There are also some short cuts at one end of the room that you can't see because of a fridge and a dining table. But its the lesser of two evils. Better than having a 2 metre long, 50mm wide turd in the kitchen. Nothing is going to get moved around in the near future, and my missus is happy with it.
 
O

Old Mod

Ok John I'll apologise,I may have focused on your last sentence more than the whole post.
Bit of a knee jerk reaction on my part.
My intention was to say that, the fact that furniture will be covering that side of the room isn't really being considered as a setting out factor, it's being considered more as a compromise to give the overall desired effect.
I'll try not to respond in haste cos I'm walking out the door in future. :)
 
B

Bill

I don't centre any floor. I just tile it how it will look best for the tiles and room. If that means starting with a full tile from the rooms focal point then so be it, the same can be said if I centre it. Unless you are tiling a repetitive area then each job should be set out on its own merits.

Now that is the best advice on this subject and I expect a trusted advisor badge forthwith.
 
I

Italy

I don't centre any floor. I just tile it how it will look best for the tiles and room. If that means starting with a full tile from the rooms focal point then so be it, the same can be said if I centre it. Unless you are tiling a repetitive area then each job should be set out on its own merits.

Now that is the best advice on this subject and I expect a trusted advisor badge forthwith.
I can give you mine if you want...:) I do not need, I'm already over the badge green ;)
 

Reply to How best to Tile a room? in the DIY Tiling Forum area at TilersForums.com

Subscribe to Tilers Forums

There are similar tiling threads here

Hi, Looking for advice mainly on how much adhesive I should remove from between the tiles in a...
Replies
1
Views
1K
    • Like
We had a wet room fitted by a large company. We have issues with a few large steps where the...
Replies
3
Views
303
Hi. We've had a bathroom installed with electric mat underfloor heating in a new extension. The...
Replies
6
Views
318
    • Like
Hi guys. Im a carpenter who has tiled a fair few floors over the years as i fit a lot of...
Replies
13
Views
2K
Hi, Can anyone please give me some advice. I have an old bathroom and I want to turn it into a...
Replies
1
Views
1K

DIY Tiling Advice Forum

Trending DIY Tiling Forum Threads

Wetroom and Tanking Systems Popular

Advertisement

Thread Information

Title
How best to Tile a room?
Prefix
N/A
Forum
DIY Tiling Forum
Start date
Last reply date
Replies
530

Which tile adhesive brand did you use most this year?

  • Palace

    Votes: 9 5.8%
  • Kerakoll

    Votes: 15 9.7%
  • Ardex

    Votes: 11 7.1%
  • Mapei

    Votes: 45 29.0%
  • Ultra Tile

    Votes: 19 12.3%
  • BAL

    Votes: 37 23.9%
  • Wedi

    Votes: 4 2.6%
  • Benfer

    Votes: 2 1.3%
  • Tilemaster

    Votes: 21 13.5%
  • Weber

    Votes: 18 11.6%
  • Other (any other brand not listed)

    Votes: 17 11.0%
  • Nicobond

    Votes: 7 4.5%
  • Norcros

    Votes: 3 1.9%
  • Kelmore

    Votes: 4 2.6%
Top