Is this an acceptable edge cut?

[WetSaw]

Strangely if someone quotes the post before the price has been taken out it still shows in the quoted text. So if you want to know it's there to be seen...

 

[One Day]

Strangely if someone quotes the post before the price has been taken out it still shows in the quoted text. So if you want to know it's there to be seen...

now they'll go and fix that bug! Should have kept quiet!

 

[Old Mod]

now they'll go and fix that bug! Should have kept quiet!

If I'd been paying attention Mark I'd of removed it, I normally do.

 

[Old Mod]

It's all immaterial anyway, I pm'd Martyn the price a couple minutes after he posted cos he was so upset.

 

[dave l and l]

the price is still on the thread on the 1st page

 

[Flintstone]

Heavy price for that area and those tiles, even for a quality finish, imo!

 

[Dumbo]

Lads calm down.

We're discussing a cut tile not the end of the world.

PM the OP if you want to know the price, that's fine if they're happy with it. But it's not really going to justify the cut even if it was the whole job for 50p.

Agreed if someone's says they can do it for a price they should be held accountable for good quality work if they can't do it for that price or if they just can't do it maybe they wouldn't go around quoting cheap prices ( sorry don't know cost of this job and sorry for going of topic a bit )

 

[Dumbo]

the price is still on the thread on the 1st page

Not on my feed (just read the thing about quoted text sorry )

 

[Old Mod]

Not on my feed (just read the thing about quoted text sorry )

Of course it's on your feed, everyone see the same thing.
Antonio quoted it on the first page.

 

[jamesbond]

Thanks to all of you for all your valuable opinions and advice. It is very much appreciated.

We were completely ready to eat humble pie, accept the level of quality and put it down to experience had we learned we had paid well below par and received only what we paid for. However, we are relieved to have learned, thanks to your kind insight, that we were justified to expect a certain of quality given what we are being expected to pay.

It's also a great relief to hear that there is a bare minimum that you all feel should be expected regardless of cost, and that our expectations are well in line with this. We never expect perfection at any price, but we also don't expect a finish like that! It's good to know a clean cut is not too much to ask, that it's fair to expect tiles to be in line with each other, and that our dissatisfaction was reasonable. We don't want to fobbed off, but don't want to be unfair either.

Thanks again for all the great advice and insight.

 

[Old Mod]

Thank you, appreciate your feedback.
Comments like yours give us the encouragement to carry on, as we're all here voluntarily.
Hope you find a satisfactory resolution.

 

[Dougs Third Go]

are the cuts acceptable?....most certainly not, regardless of price paid. There's no need to use an angle grinder for the L shaped edges anyway, score the edges with hand cutter then use an angle grinder to cut into the corner from the waste edge and just snap them out with your cutter.

 

[Italy]

Is this an acceptable edge cut?
Yes,Just spend the money on the tools
Ps tile very hard

 

[Simons70]

Is this an acceptable edge cut?
Yes,Just spend the money on the tools
Ps tile very hard

View attachment 92215 View attachment 92216 View attachment 92217 View attachment 92218 View attachment 92219

Oh,nooo,where is 45 on trims???

 

[Italy]

Oh,nooo,where is 45 on trims???

really???
Is 3mm ....