Adhesive/Grout etc to buy tomorrow....

[Scott]

I saw a cheap one in homebase at the weekend. For the amount you are doing you dont need an expensive one.

 

[kevg]

I saw a cheap one in homebase at the weekend. For the amount you are doing you dont need an expensive one.

Yeah, I'm going to head to B&Q or Homebase over the weekend and pick up something suitable.

 

[kevg]

What do you guys use to take skirtings off ?

I was thinking a chisel, hammer and a jimmy bar ?

I obviously need to reuse it again, is there any tips for safe removal witout damaging the wall etc ?

Because its a new build house, I imagine they would have glued the skirting on rather than nailing it ?

 

[White Room]

Has it been decorated

 

[kevg]

Has it been decorated

Walls and skirting have been painted yeah. No floor laid in the places I will be tiling.

 

[White Room]

If you start pulling off skirting then someone will need to do some snagging, I would cut to the skirting rather than rip off IMO

 

[kevg]

If you start pulling off skirting then someone will need to do some snagging, I would cut to the skirting rather than rip off IMO

You think it would look ok doing it like that ? Just use a small amount of sealant along the join to finish off ?

 

[White Room]

Yes mate, Silicon will be fine..

I've had to loads of times, if it's decorated try convincing someone why your ripping off their skirting and explaining the repair bill.

 

[kevg]

With regards to Priming....

I have the SBR Primer to prime the no more ply boards. What should I use for my concrete floors ? Would Primer G be ok ?

What I dont get is the SBR primer should be used prior to fitting the no more ply. So that means I'm priming the chipboard floors I have ? Why is that needed if I am glueing and screwing no more ply directly on to the chipboard ? Wouldnt I prime the no more ply itself ?

 

[Scott]

You need to prime the floor first to alow for the adhesive to bond to it.

 

[kevg]

You need to prime the floor first to alow for the adhesive to bond to it.

No adhesive between the woodchip and the no more ply, just glue and screws.

So I would just prime the no more ply ? Would you recommend a 1:1 dilution ? Or a couple of coats of 1 primer 3 water (1:3) ?

 

[White Room]

No adhesive between the woodchip and the no more ply, just glue and screws.

So I would just prime the no more ply ? Would you recommend a 1:1 dilution ? Or a couple of coats of 1 primer 3 water (1:3) ?

Have you glued the no more ply onto woodchip

 

[kevg]

Have you glued the no more ply onto woodchip

No not yet. I'm not laying anything till the weekend.

 

[White Room]

No need to prime the no more plymate, it's a cement board

Just found a link, they say prime the surface to be tiled

Broken Link Removed Please read

 

[Scott]

If the floor is dusty the glue wont stick, hence the primer