Electrical Advice

Need Advice on ATS for PV System. Discussion ThreadNeed Advice on ATS for PV System. Electrical Advice

Does Anyone know of a switch or ATS that can work in the diagram attached?

Was told by the manufacturer that these inverters can work solely as hybrid inverters. However it appears the ATS Inside the Hybrid inverter can not be avoided. Under Normal circumstances the Inverters want to sit in between the grid and the load but that is not acceptable in this system as even when the...

 

Uh oh...shorted MICC. How scr*wed am I? Discussion ThreadUh oh...shorted MICC. How scr*wed am I? Electrical Advice

I've just been fettling some 50 year old 2L2.5 pyro (MICC) to relocate a plug socket. I probably bent the cable a little more than I should have (although I didn't feel it was particularly tight when I did it) when I was doing the fettling, but now I've pulled the cable straightish again, I seem to have a short across the live, neutral and earth on the cable in question...

 

Getting Older and Slower Discussion ThreadGetting Older and Slower Electrical Advice

Hi everyone.
I’m now 50 and find myself taking twice as long doing things that in my head should not be taking as long.
Not sure if it’s an age thing or a state of mind I also find myself double checking things more.
I know I may be comparing to my younger self, who was bought up on a diet of local authority occupied rewires and Bovis new builds, where speed was more of a priority than anything...

 

Amps & generator load Discussion ThreadAmps & generator load Electrical Advice

Year 2002 two ton 240vac hvac compressor. Plaque says 21.4 amps. Paperwork says use 30a dbl breaker.

Is that 21.4 amps on each hot wire?

Air handler central hvac 120vac fan paperwork says 6.2 amps

2 fridges in house. Plaques say 6.5 & 4.5a. 120vac.

Both fridges on same hot. The 6.2 amp central fan is on the other hot.

Only other things running were modem\router and two phone charges. Smart tv &...

 

need to replace thermostat help Discussion Threadneed to replace thermostat help Electrical Advice

Hi, cm921 honeywell thermostat is old and need a new one so i ordered a new replacement (picture below). This new one i bought which is coming tomorrow has a receiver not sure if I have to wire it up but I assume i have to, its hannicks brand but ill see if it can pair with honeywell maybe it does idk, so I was thinking if I won't be needing the wired honeywell receiver at the boiler I...

 

Is an eicr still valid if company that carried it out goes into liquidation Discussion ThreadIs an eicr still valid if company that carried it out goes into liquidation Electrical Advice

Hi all
Quick question, is an eicr still valid if the company that carried it out goes under.

Is an eicr still valid if company that carried it out goes into liquidation for the original thread on Electricians Forums

 

Help wires for outside lights Discussion ThreadHelp wires for outside lights Electrical Advice

Hi I have a small problem had new windows fitted to my porch and the guys that fitted them took down my old lights and left the wires out ready for me to put new ones up only when I did put the new ones up they didn’t work only to find out that they have removed 2 of the wires from the switch but they did mark them as outside light wires but am still waiting for them to call back but that...

 

How long would this take you to do, on price? Discussion ThreadHow long would this take you to do, on price? Electrical Advice

Good evening all, need some guidance with time management and pricing. I haven’t really done any price work before and recently becoming self employed I’ve been offered to do these 1 bed disabled flats on price.

I’ll be second fixing everything here’s the list

10-12 way board + test

pendants - 6

Fluorescent light - 1

Light for bathroom - 1

Extractor...

 

Contactor wiring with Nest thermostat Discussion ThreadContactor wiring with Nest thermostat Electrical Advice

Hello, I'm trying to get a contactor to work with a nest thermostat to activate an oil filled heater rather than a boiler.


I wired permanent live and neutral to the two poles at the top of the connector (1+3), switched outputs to the bottom (2+4) then the common and demand lines from nest to A1 and A2.


There's a click from the contactor when demand is called but no...

 

Shed feed line Discussion ThreadShed feed line Electrical Advice

Hi
Here is my scenario. I want to install a 20A 240v service to my shed. Hoping to use a defunct SPA panel left by the PO- a 50A CH50SPA on the side of the house.. Recently, I've had landscaping work done that is between the house & shed and while the landscapers were doing that I had them run a 3/4" SCH40 conduit from the SPA panel to the shed. The 50A service to the SPA panel from the house breaker panel is #6/3 w/...

 

Skills Assesment Australia Discussion ThreadSkills Assesment Australia Electrical Advice

I am in the early stages of applying for my permanent residence visa for Australia, for this I have to get my skills assesed at the Downunder Centre in London. Has anybody been through this company and have the same assessment, if so any heads up and what sort of things are likely to come up. I have heard they're are some parts to draw out a DOL motor circuit. Not done much with motors so may...

 

Extending wires in consumer unit. Discussion ThreadExtending wires in consumer unit. Electrical Advice

Hi, everyone.

I need to move a circuit to an MCB at the other end of a split load board.

The cables all enter the CU at one end, and the cables in question will not reach the breaker at the other end without extending them. It is a ring final circuit.

What's the best method to do it? I was going to use in line crimps with heat shrink over. Would that be OK?

Any advice...

 

How is the direction of this motor controlled Gauge door opened ( 240v AC) Discussion ThreadHow is the direction of this motor controlled Gauge door opened ( 240v AC) Electrical Advice

How is the direction this motor spins controles from what I can trace the white is directly attached to the neutral. ( Might be wrong on that, ) Thanks in advance, Simon...

 

How to get rid of all these ads Discussion ThreadHow to get rid of all these ads Electrical Advice

It’s near on impossible for me to look at or reply to threads on here as can’t see them properly do to crazy number of ads.

I appreciate it funds the site but it isn’t user friendly well not for me.

Thanks

How to get rid of all these ads for the original thread on Electricians Forums

 

10mm LSF cable for shower Discussion Thread10mm LSF cable for shower Electrical Advice

Hello all you fine folk and hope you're all keeping well.

Having a bit of a dilemma here regarding making off 3x10sq LSF cable for a shower. I'm debating about about whether to use a crab tree pull chord or to just mount a 2 gang 45/50A shower switch. Shower rating is 9.8kw with cable being clipped direct to timber joist in attic. I don't want to rule out the possibility that the cables could be...

 

Help with Permit to Work, Planned program of works (domestic) Discussion ThreadHelp with Permit to Work, Planned program of works (domestic) Electrical Advice

Hi
I've nearly completed the 2357 NVQ. I'm just a bit stuck with Permits to work, Planned program of work and method statements.

I work in the domestic sector majority of the time just me and my employer (7/8 years now) so as you can imagine we dont really carry out documentation like that. Could someone maybe give me an...

 

faild napit annual assessment with silly mistake of using type AC rcd instaed of type A Discussion Threadfaild napit annual assessment with silly mistake of using type AC rcd instaed of type A Electrical Advice

i have faild napit annual assessment with silly mistake of using on consumer unit type AC rcd instead of Type A rcd. i bought type A rcd but they wre type AC someone swap them inside the packege. but i understaind its my mistake i should have checked it. now i have changed...

 

Spit pulsa 800e with extras Discussion ThreadSpit pulsa 800e with extras Electrical Advice

This is in excellent condition, very little use

Spit 800e
3 batteries
Magnetic washer guide ( rrp £200)
2 boxes of nails
3 gas
Original case - excellent condition
£350

...

 

4 pole rotary isolator... Switch the neutral or not? Discussion Thread4 pole rotary isolator... Switch the neutral or not? Electrical Advice

Hi there,

Just a quick question. I am rectifying many problems on some 3 phase immersion heater circuits in a plant room. There are 4 pole rotary isolators just before the immersion elements and the earthing arrangement is TN-S.

I noticed that the neutrals are connected into a dedicated linking terminal to the side, as opposed to the 4th pole...

 

extending cables in CU Discussion Threadextending cables in CU Electrical Advice

Hi
Could some one help. You come across a CU relacement job and you realise cables are too short. What would you do to extend the cables? I could think of 2 options:
1. cutting the wall to expose the cables and move the CU
2. Using crimp connectors to extend conductors.
Is there a profi system out there? Someone was talking about a rail connector system???

thank you

extending cables in CU for the...

 

London Rewire Pricing + Late Invoicing Discussion ThreadLondon Rewire Pricing + Late Invoicing Electrical Advice

Hi all,

I posted here some time ago asking for validation of a quote I received for a rewire. (10k assumed 60 points) And got some good advice so I'm back and could do with some help please.

The work has been done but ended up costing more than anticipated.

Additionally despite my request for a payment schedule to be provided throughout it has only been sent 4 months...

 

Led downlights flick on/off when switched on Discussion ThreadLed downlights flick on/off when switched on Electrical Advice

Replaced an outside mains pir light which works, but none of the other lights work, except the one it runs off. I took the wiring off the circuit, essentially back to how it was before, but I still have no lights indoors. When I switch downlights on the flicker! Any help would be fantastic please.

Led downlights flick on/off when switched on for the...

 

Spend £250 (ex vat) and Get Draper VDE Pliers for FREE! Discussion ThreadSpend £250 (ex vat) and Get Draper VDE Pliers for FREE! Electrical Advice

Hi everyone,

If you spend £250 (ex vat) this weekend on E2GO, remember to add Draper VDE Pliers (63216) to your basket and use the code: FREEVDE to get them for absolutely FREE!

Hurry though, this offer is limited to the first 50 customers! Once the stock’s gone, the code won’t work, so don’t miss out!

Have a great...

 

RCD tripping only when high draw device and lighting ring is on. Discussion ThreadRCD tripping only when high draw device and lighting ring is on. Electrical Advice

Hi.

Wondering if anyone had any idea what might be happening. Last night I damaged a pendant light fitting by accident, not enough to stop it working.
However later in the evening when my car charger started at 11:30PM the whole house RCD tripped.
I only thought back to the light accident as the one thing that had...

 

Electric meter issue with fcc id not found Discussion ThreadElectric meter issue with fcc id not found Electrical Advice

When trying to look up the FCC id number from my electric meter, nothing is found on federal communications commission database. Why would this be? Have a call into customer service, no answers yet. Grantee code shows many devices but product code shows nothing found. Has anyone else had this issue? Thanks

Electric meter issue with fcc id not found for the...

 

Can i install a new circuit or do minor works on a plastic consumer unit under the stairs which is the only escape route. Discussion ThreadCan i install a new circuit or do minor works on a plastic consumer unit under the stairs which is the only escape route. Electrical Advice

I know it's only a C3 but I've been to quote jobs where previous electricians have told the client that they have to get it replaced to comply with current regulations which is false and basically scaring the...

 

Dimmer switch and normal switch on an intermediate switch Discussion ThreadDimmer switch and normal switch on an intermediate switch Electrical Advice

Probably a silly question as I haven’t come across it yet.

On a 2 way switch I assume a dimmable lamp will work ok with 1 switch on a dimmer and the other on a normal light switch? So no dim when the normal light switch is pressed (just on/off) but when the dimmer switch is used the light will be dimmed?

Also assuming the same...

 

Door bell installation Discussion ThreadDoor bell installation Electrical Advice

I can't add to comments in the DIY area for some reason, but I'm opening this thread so I can make a comment.
@littlespark made a very useful comment that you can still get the old "Ding-Dong" chimes and frankly I think they are great! Batteries last for years, no mains voltage, really nothing to go wrong. I have one, all my neighbours have them, they were fitted as standard when the flats were...

 

Anyone have a spare Legrande trunking marker? Discussion ThreadAnyone have a spare Legrande trunking marker? Electrical Advice

Hi guys,

Looking to see if anyone has one of these legrande/Salamandre jig markers lying around. Mine seems to have gone walkabouts. They were free a while back but I’m happy to pay for one if anyone has one spare. Don’t think they do them anymore and I’ve looked everywhere.

Thank...

 

Another lovely old test meter... Discussion ThreadAnother lovely old test meter... Electrical Advice

Robin M1015 MegOhm Insulation Continuity Tester Electricians Tool for sale online | eBay ​

Find many great new & used options and get the best deals for Robin M1015 MegOhm Insulation Continuity Tester Electricians Tool at the best online prices at eBay! Free delivery for many products!
www.ebay.co.uk...