1st big porc job..

[dboden]

Hi everyone... well I knew it would come soon, I have my first big tile porcelain job!! gulp..
20+ metres of wall with a 1m x 350mm porc tiles, and then similar on 5m floor.
I,m not too worries about the floor.. But I,m bricking it for the walls!!
Any tips and advice welcome.

ps, I think we are hiring a big wet cutter, and I have a Sigma B2M
also,
I was thinking of using this, do you think it will be ok?
https://www.emctiles.co.uk/main/product/productinfo/618/TA Trade FlexiRapid White 20Kg/1

 

[dboden]

ps.. porcelain job..... not porch job!!!

 

[streaky]

Take your time and don't panic lol

 

[Deleted member 9966]

Hi db, I've edited your thread title so it says porc not porch!

 

[John Benton]

With that size tile you will have to make sure that the walls have a flat plane, vertical and horizontal with a tolerance of maybe 2-3mm maximum other wise you will be padding out with addy, not a good idea.

Use a slow set rather than rapidset as well, give yourself some time and take your time don't rush it!!!

 

[dboden]

Would you say, just a 10mm notched straight on the wall!

 

[streaky]

I would say 8 mm would be fine as well as it's not to worn.

 

[andyb1]

Use slow set, you'll end up throwing half of that rapid away,

 

[White Room]

I'd be using rapid set personally for the first few rows of tiles....

 

[John Benton]

Would you say, just a 10mm notched straight on the wall!

8/10mm and back butter the tiles with flat edge of trowel